The Alternative Smoking Experience
20 Jun
Please read before use to ensure full and proper function of your newly purchased SmokeStik.
Congratulations and thank you for purchasing the SmokeStik.
Special Notes:
Product Has a 3 Second cut-off: if your drag is longer than three seconds your SmokeStik “cuts-off” to prevent overheating.
Preventing Over-Usage: If you take more than 16 drags within one minute, your battery will flash continuously 10 times to indicate over-usage. Please refer to this manuals Troubleshooting page if you SmokeStik is not working properly. If you are still unable to ascertain the problem, please contact us at service@discountsmokstik.com.
Product Information
WHAT IS A SMOKESTIK?
A SmokeStik is a revolutionary device that resembles a traditional cigarette and fully recreates the smoking experience, including “smoke” without any harmful side effects.
It is a clean alternative to traditional cigarette smoking. It is free of carbon monoxide, tar, and the cancer-causing chemicals found in traditional cigarettes and cigars. A SmokeStik is essentially litter-less in that it is free of ashes and stubs. Also, it is much safer since it is free of fire.
What you are “smoking” is a mist or vapor. This vapor is created as liquid nicotine and propylene glycol are vaporized by a tiny component called the atomizer.
KEY PRODUCT BENEFITS
HOW DOES IT WORK?
The mouthpiece (filter) contains a replaceable cartridge filled with liquid. The main substances contained in the liquid are nicotine, propylene glycol, and optional flavours.
When you take a drag on the SmokeStik, the air flow is detected by a tiny sensor. A microprocessor then activates the atomizer which injects tiny droplets of the liquid into the flowing air and vaporizes the nicotine. This produces a vapor mist which you inhale – just like smoke from a traditional cigarette. You get the nicotine delivery without any of the harmful chemicals or tar that traditional cigarettes contain! An orange LED at the tip of the device is also activated to simulate the burning end of a lit cigarette.
A high-density Lithium Ion battery powers the device and will last all day on a normal charge. Your starter kit will include two batteries so that you may use one while your second battery is recharging.
BATTERY COMPONENTS AND CHARGER
The SmokeStik employs a 3.6V special lithium battery and unique charger which cannot be replaced with other lithium batteries or chargers. The input supply voltage of the charger must be Ac100V-240V, 50/60Hz, or DC6-24V.
INSTRUCTIONS FOR FIRST TIME USE
The four main components to your new Smokestik are the filter, cartridge, the atomizer and the battery.
REPLACING THE CARTRIDGE
When your cartridge runs out, your SmokeStik will stop producing “smoke” and you will notice that the flavor of the product is gone. When this happens, you will need to replace the cartridge.
To replace the cartridge, simply pull the filer off the end of the SmokeStik (DO NOT UNSCREW IT), remove the old cartridge, and discard both the filter and cartridge. Open a new cartridge and insert it into the atomizer, open end first, then slide the new filter over the cartridge securely.
CARTRIDGE FAQs
Q: How long will a cartridge last?
A: That depends solely on your usage patterns. Some users will go through 1 or less cartridges a day, while heavy users may go through 2 or more per day. One cartridge is roughly equivalent to 1/2 of a pack of traditional tobacco cigarettes.
Q: How do I know when the cartridge is finished?
A: When your cartridge runs out, your SmokeStik will stop producing “smoke” and you will notice that the flavor of the product is gone. When this happens you will need to replace the cartridge.
Q: How much nicotine is in the cartridge?
A: Cartridges are available in varying nicotine doses and flavors. Smoke Stik supplies two main flavors (regular and menthol). Each of these two flavors are further availabe in four nicotine strengths: High – 14mg, Medium – 8mg, Low – 4mg and No Nicotine.
REPLACING THE BATTERY
To change the battery in your SmokeStik, gently unscrew the atomizer (filter end) of the unit from the discharged SmokeStik and screw it back onto the new fully-charged SmokeStik.
Note: There is only ONE atomizer in your kit-this is the silver colored metal extending from the end of he SmokeStik. The white, jet black or platinum portion of the SmokeStik contains the actual battery. This is the only part that will screw onto the charging unit and the only time you will ever need to unscrew the atomizer is to screw it into your spare SmokeStik battery. You do not need to unscrew the atomizer unit in order to change your cartridge.
BATTERY FAQs
Q: How do I recharge my battery?
A: Simply screw the battery into the charger. At this point, the charger’s indicator light will turn to red. Once the charge is complete, the light will change from red to green. Typically, it takes about 3 to 4 hours to fully recharge the battery. Keep in mind, your smokeStik package includes 2 batteries so that you can recharge one while the other is in use. The frequency of recharging your battery will depend on how often you inhale.
Q: How do I know when to recharge my battery?
A: When your battery begins to flash continuously for about 9 seconds, you will need to recharge your battery.
TROUBLESHOOTING
CAUTIONS
SUITABLE USERS
This product MUST NOT be sold to :
This product is NOT intended for and should not be sold to:
This product is most suitable for:

One Response for "SmokeStik User’s Manual"
Pretty cool post. I just found your blog and wanted to say
that I’ve really liked browsing your blog posts. Any way
I’ll be subscribing to your blog and I hope you post again soon!
Leave a reply